View source for Change the default linear units in VTube

<table>
<tr cellpadding=10>
<td width=225>
[[image:vtube-step_logo.jpg|200px]]<br>
[[image:vtube-laser_logo.jpg|200px]]
* Back to [[VTube-STEP]]
* Back to [[VTube-LASER]]
</td>
<td width=300>
[[image:Vtube-step_1_65.jpg|300px]]
</td>
</tr>
</table>

__NOTOC__


===[[image:Check.jpg|25px]] Steps to changing the default linear units===

<table>

<tr>
<td width=300>
Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active.</td>
<td>
[[image:vtube-step_toolbar_clear_units.jpg|400px]]
</td>
</tr>
<tr>
<td width=300>
Press the System Options button.</td>
<td>
[[image:vtube-step_toolbar_sys.jpg|400px]]
</td>
</tr>
<tr>
<td width=300>
Press the Project Setup tab, and then press the Set Project Default State button.</td>
<td>
[[image:vtube-step_setprojdefaultstate.jpg|400px]]
</td>
</tr>

<tr>
<td width=300>
Exit the System Options menu.  VTube will now clear to the new linear unit.
</td>
<td>
</td>
</tr>

</table>
<br>

==Other Pages==

*Back to the [[VTube]] page