View source for VTube-STEP v1.59

<table>
<tr cellpadding=10>
<td width=225>
[[image:vtube-step_logo.jpg|200px]]
==Revision 1.59==
* Back to [[VTube-STEP]]
* Back to [[VTube-LASER]]
</td>
<td width=300>
[[image:vtube-step_maincreen.jpg|300px]]
</td>
</tr>
</table>

__NOTOC__


===[[image:Check.jpg|25px]] FIX- Supravision Output Fix to the Rotation Values===

<table>

<tr>
<td width=300>
The rotation values are now recorded properly in the Supravision output files and the Supravision data sent through the bender interface menu.</td>
<td>
</td>
</tr>

</table>
<br>

===[[image:Check.jpg|25px]] ENHANCEMENT- Part Name is Used as Filename When Part Name Changes ===
<table>
<tr>
<td width=300>
In previous versions, the part name was used as the filename only if the previous filename was empty.
<br><br>
Now - when the part name '''changes''', the part name is used as the initial filename in the Save dialog.</td>
<td>
[[image:vtube_savefile_partname.jpg]]
</td>
</tr>
</table>

<br><br>

===[[image:Check.jpg|25px]] ENHANCED- Linear Units Now Set By Single Large Button ===
<table>
<tr>
<td width=200>
In previous versions, the linear units radio buttons were not reliable in setting the proper state.
<br><br>
Plus they were too small to easily press.
<br><br>
This version removes these radio buttons and uses an large button with either an M or an I that toggles the state.
<br><br>
These buttons can also be localized.  The M and I can be changed to other Unicode characters for other languages.</td>
<td>
Old Interface:
<br>
[[image:vtube_laser_linear_units.jpg]]
<br>
New Interface:
<br>
[[image:vtube_laser_linear_units_button_millimeter.jpg]]
<br>
[[image:vtube_laser_linear_units_button_inch.jpg]]
<br>
</td>
</tr>
</table>

<br><br>

==Other Pages==

*Back to the [[VTube]] page