Difference between revisions of "Measure Large Diameter Tubing"
From ATTWiki
(→Wide Scan Technique) |
(→Wide Scan Technique for Large Diameters) |
||
| Line 24: | Line 24: | ||
For diameters 6" and greater, you can switch to the wide-scan technique. On larger diameters, it is important to scan in points from a wider area of the tube.<br><br> | For diameters 6" and greater, you can switch to the wide-scan technique. On larger diameters, it is important to scan in points from a wider area of the tube.<br><br> | ||
* First scan one end. | * First scan one end. | ||
| − | * Second - move to the other end, and rotate the probe around the tube slightly. We recommend about 90 degrees of rotation. Then scan the new end and new side of the cylinder. | + | * Second - move to the other end, and rotate the probe around the tube slightly. We recommend about 90 degrees of rotation. Then scan the new end and new side of the cylinder.<br><br> |
This will give the math engine much better data to fit the centerline to | This will give the math engine much better data to fit the centerline to | ||
Revision as of 18:21, 11 July 2012
|
|
|
Wide Scan Technique for Large Diameters
|
VTube is immune to diameter sizes if you follow techniques to handle larger diameters.
This will give the math engine much better data to fit the centerline to |
Other Pages
- Back to VTube-LASER
