Difference between revisions of "CNC Bender v12.1.2"

From ATTWiki
Jump to: navigation, search
(→‎25px ENHANCED: Motion Recovery Logic)
(→‎25px ENHANCED: Motion Recovery Logic)
Line 20: Line 20:
 
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.<br><br>
 
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.<br><br>
  
−
Now the motion-recovery logic is adjusted so that motion-recovery is no longer attempted to recover motion in these circumstances:
+
===Old Behavoir===
 +
CNC Bender attempts motion-recovery in every mode - even MANUAL mode.
 +
 
 +
===New Behavoir===
 +
CNC Bender motion-recovery is no longer attempted to recover motion in these circumstances:
  
 
* The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
 
* The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.

Revision as of 19:30, 30 August 2013

v12.1.2 - August 30, 2013

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.

Old Behavoir

CNC Bender attempts motion-recovery in every mode - even MANUAL mode.

New Behavoir

CNC Bender motion-recovery is no longer attempted to recover motion in these circumstances:

  • The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
  • The bender has encountered a FAULT condition.
  • The bender has encountered a command that is timed out.
  • The E-Stop is pressed.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12.1.2&oldid=22902"