Difference between revisions of "CNC Bender v12.1.2"
From ATTWiki
(→25px ENHANCED: Motion Recovery Logic) |
(→New Behavoir) |
||
| Line 24: | Line 24: | ||
===New Behavoir=== | ===New Behavoir=== | ||
| − | CNC Bender | + | CNC Bender no longer attempts to recover motion in these circumstances: |
* The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode. | * The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode. | ||
Revision as of 19:31, 30 August 2013
v12.1.2 - August 30, 2013
|
|
ENHANCED: Motion Recovery Logic
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.
Old Behavoir
CNC Bender attempts motion-recovery in every mode - even MANUAL mode.
New Behavoir
CNC Bender no longer attempts to recover motion in these circumstances:
- The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
- The bender has encountered a FAULT condition.
- The bender has encountered a command that is timed out.
- The E-Stop is pressed.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
