Difference between revisions of "CNC Bender v12.1.2"
From ATTWiki
(→New Behavoir) |
(→New Behavoir) |
||
| Line 27: | Line 27: | ||
* When the operator presses any HALT button. | * When the operator presses any HALT button. | ||
| − | * The bender is in MANUAL | + | * The bender operation mode is in MANUAL. |
* The bender has encountered a FAULT condition and motion is stopped. | * The bender has encountered a FAULT condition and motion is stopped. | ||
* The bender has encountered a command that is timed out and motion is stopped. | * The bender has encountered a command that is timed out and motion is stopped. | ||
Revision as of 19:56, 30 August 2013
v12.1.2 - August 30, 2013
|
|
ENHANCED: Motion Recovery Logic
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.
Old Behavoir
CNC Bender attempts motion-recovery in every mode - even MANUAL mode.
New Behavoir
CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:
- When the operator presses any HALT button.
- The bender operation mode is in MANUAL.
- The bender has encountered a FAULT condition and motion is stopped.
- The bender has encountered a command that is timed out and motion is stopped.
- The E-Stop is pressed and released, and motion is restarted. (This is the same as previous versions.)
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
