Difference between revisions of "CNC Bender v12.1.2"
From ATTWiki
(→25px ENHANCED: Motion Recover Logic) |
(→New Behavoir) |
||
| (11 intermediate revisions by one user not shown) | |||
| Line 18: | Line 18: | ||
==[[image:Check.jpg|25px]] ENHANCED: Motion Recovery Logic == | ==[[image:Check.jpg|25px]] ENHANCED: Motion Recovery Logic == | ||
| − | Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start | + | Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.<br> |
| − | + | ===Old Behavoir=== | |
| + | CNC Bender attempts motion-recovery in every mode - even MANUAL mode. | ||
| − | * The bender is in MANUAL | + | ===New Behavoir=== |
| − | * The bender has encountered a FAULT condition. | + | CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances: |
| − | * The bender has encountered a command that is timed out. | + | |
| − | * The E-Stop is pressed. | + | * When the operator presses any HALT button. |
| + | * The bender operation mode is in MANUAL or is entering MANUAL mode. | ||
| + | * The bender has encountered a FAULT condition and motion is stopped. | ||
| + | * The bender has encountered a command that is timed out and motion is stopped. | ||
| + | * The E-Stop is pressed and released, and motion is restarted. (This is the same as previous versions.) | ||
| + | |||
| + | <br><br> | ||
==Other Pages== | ==Other Pages== | ||
Latest revision as of 19:57, 30 August 2013
v12.1.2 - August 30, 2013
|
|
ENHANCED: Motion Recovery Logic
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.
Old Behavoir
CNC Bender attempts motion-recovery in every mode - even MANUAL mode.
New Behavoir
CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:
- When the operator presses any HALT button.
- The bender operation mode is in MANUAL or is entering MANUAL mode.
- The bender has encountered a FAULT condition and motion is stopped.
- The bender has encountered a command that is timed out and motion is stopped.
- The E-Stop is pressed and released, and motion is restarted. (This is the same as previous versions.)
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
