Difference between revisions of "CNC Bender v14.7"
From ATTWiki
(→25px FIX: Version 14 Is Now Compatible with I2T or Galil Modules) |
|||
| Line 2: | Line 2: | ||
<tr> | <tr> | ||
<td width=400> | <td width=400> | ||
| − | ===v14.7 - July | + | ===v14.7 - July 11, 2014=== |
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
*See [http://advancedtubular.com/customers/cncbender CNC Bender Customer Service Page] for an update. | *See [http://advancedtubular.com/customers/cncbender CNC Bender Customer Service Page] for an update. | ||
| Line 16: | Line 16: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ==[[image:Check.jpg|25px]] | + | ==[[image:Check.jpg|25px]] ENHANCED: Version 14 Is Now Compatible with I2T or Galil Modules== |
<table> | <table> | ||
Revision as of 22:33, 24 July 2015
v14.7 - July 11, 2014
|
|
ENHANCED: Version 14 Is Now Compatible with I2T or Galil Modules
|
Version 14 introduced compatibility with the new Galil module. This revision allows version 14 to communicate with legacy I2T modules also. |
|
NEW: "Custom ALL DIES Open" Option
|
This new option, when enabled, allows the operator to take over the control of the dies opening using CUSTOM COMMANDS. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
