Difference between revisions of "CNC Bender v14.9-r10"
(→25px ENHANCEMENT: SUPRAVISION Communications) |
(→25px ENHANCEMENT: Cross Slide Check) |
||
| Line 20: | Line 20: | ||
<tr> | <tr> | ||
<td width=500> | <td width=500> | ||
| − | In previous versions of CNC Bender, the internal logic would not allow the manual | + | In previous versions of CNC Bender, the internal logic would not allow the manual jog close of either PRESSURE die or CLAMP die if the Cross Slide INPUT for AWAY from die (or in the home position) was active.<br><br> |
This has been changed so that CNC Bender now only examines the Cross Slide INPUT for ADVANCED or IN the die active.<br><br> | This has been changed so that CNC Bender now only examines the Cross Slide INPUT for ADVANCED or IN the die active.<br><br> | ||
'''This allows for locking the carriage cross slide for little or no movement - with both prox switched active at the same time - and still close the dies.''' | '''This allows for locking the carriage cross slide for little or no movement - with both prox switched active at the same time - and still close the dies.''' | ||
Revision as of 14:21, 12 March 2016
v14.9-r10 - March 10, 2015
|
|
ENHANCEMENT: Cross Slide Check
|
In previous versions of CNC Bender, the internal logic would not allow the manual jog close of either PRESSURE die or CLAMP die if the Cross Slide INPUT for AWAY from die (or in the home position) was active. |
ENHANCEMENT: SUPRAVISION Communication Change for ROMER Software
|
Previous versions of CNC Bender would send Supravision data with XYZ values even if the XYZ values had not been setup (and were all zeros). |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
