Difference between revisions of "CNC Bender v14.9-r10"
(→25px ENHANCEMENT: Cross Slide Check) |
(→25px ENHANCEMENT: SUPRAVISION Communication Change for ROMER Software) |
||
| Line 25: | Line 25: | ||
This caused ROMER software products to refuse the incoming data and display an error.<br><br> | This caused ROMER software products to refuse the incoming data and display an error.<br><br> | ||
'''This release of CNC Bender will automatically remove the XYZ data if they are all zeros. This satisfies the ROMER software rules.''' | '''This release of CNC Bender will automatically remove the XYZ data if they are all zeros. This satisfies the ROMER software rules.''' | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:romer_infinite.jpg]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
==[[image:Check.jpg|25px]] ENHANCEMENT: Cross Slide Check == | ==[[image:Check.jpg|25px]] ENHANCEMENT: Cross Slide Check == | ||
Revision as of 14:24, 12 March 2016
v14.9-r10 - March 10, 2015
|
|
ENHANCEMENT: SUPRAVISION Communication Change for ROMER Software
|
Previous versions of CNC Bender would send Supravision data with XYZ values even if the XYZ values had not been setup (and were all zeros). |
|
ENHANCEMENT: Cross Slide Check
|
In previous versions of CNC Bender, the internal logic would not allow the manual jog close of either PRESSURE die or CLAMP die if the Cross Slide input prox for AWAY from die (or in the home position) was active. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
