Difference between revisions of "VTube-LASER Addata ZModem Communications Protocol"
From ATTWiki
(Created page with "== About the Addata ZModem Communications Protocol== <table cellpadding=10 width=900> <tr valign=top> <td width=300> The Addata ZModem communications protocol is also known a...") |
(→About the Addata ZModem Communications Protocol) |
||
| Line 6: | Line 6: | ||
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br> | The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br> | ||
It allows for ZModem file transfer between VTube-LASER and any bender that complies with this Addata protocol.<br><br> | It allows for ZModem file transfer between VTube-LASER and any bender that complies with this Addata protocol.<br><br> | ||
| − | |||
<td> | <td> | ||
</td> | </td> | ||
Revision as of 19:15, 24 May 2017
About the Addata ZModem Communications Protocol
|
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface". |
|
|
This protocol allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Set the protocol to Addata ZModem, then click on the COM port cell to display this COM port configuration dialog. |
|
