Difference between revisions of "VTube-LASER Addata ZModem Communications Protocol"
From ATTWiki
(→About the Addata ZModem Communications Protocol) |
(→About the Addata ZModem Communications Protocol) |
||
| Line 27: | Line 27: | ||
<td width=300> | <td width=300> | ||
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br> | The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface".<br><br> | ||
| − | It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol.<br><br> | + | It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena Software bender controls.)<br><br> |
<td> | <td> | ||
</td> | </td> | ||
Revision as of 19:34, 24 May 2017
|
Addata ZModem Protocol
|
|
Contents |
About the Addata ZModem Communications Protocol
|
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface". |
|
|
VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog. |
|
