Difference between revisions of "VTube-LASER Addata ZModem Communications Protocol"
From ATTWiki
(→Video of RECALL and SEND) |
(→Video of RECALL and SEND) |
||
| Line 55: | Line 55: | ||
</td> | </td> | ||
<td> | <td> | ||
| − | [[image:vtube-laser_v2.8.3_AddataZModem Video.png|600px|link=https://www.advancedtubular.com/vtube-laser/vtube-laser_v2.8. | + | [[image:vtube-laser_v2.8.3_AddataZModem Video.png|600px|link=https://www.advancedtubular.com/vtube-laser/vtube-laser_v2.8.3_addata_zmodem_protocol.mp4]] |
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
Revision as of 20:00, 24 May 2017
|
Addata ZModem Protocol
|
|
Contents |
About the Addata ZModem Communications Protocol
|
The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface". |
|
|
VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog. |
|
Video of RECALL and SEND
| Click on the image at the right to see a RECALL/SEND with an Arena Control bender. |
|
