Difference between revisions of "Push Bending Profile Table"
From ATTWiki
| Line 2: | Line 2: | ||
[[image:Operatorstation_model.jpg|right]] | [[image:Operatorstation_model.jpg|right]] | ||
| − | [[image:Cncbender_v11_pushbend_profilesetup.jpg| | + | [[image:Cncbender_v11_pushbend_profilesetup.jpg|500px|]] |
<br><br> | <br><br> | ||
Revision as of 16:47, 25 April 2008
This is a sample Push Bend Profile Table. Each profile row contains a profile setup for a given radius. An unlimited number of profile values can be entered. Using this method of calculation, it is possible to calculate different Push Bends by indicating the bend angle.
| Value Name | Description | |
| Profile Name | The name is how the profile is displayed and selected in the Bend Options. | |
| Arm Angle | This is the final angle of the arm during push-bending. | |
| Arm vAdjust | This allows the velocity of the bend arm to be adjusted by a percentage of the original calculated velocity. | |
| Arm vAdjust | This allows the velocity of the bend arm to be adjusted by a percentage of the original calculated velocity. | |
| Feed Position | This is how far the carriage must travel to achieve the "@ Degrees" value. | |
| Feed Velocity | This is the velocity of the carriage during the bend. The velocity of the carriage is used to calculate a starting bend arm motion speed. | |
| @ Degrees | This is the angle of the tube that is achieved by the "Feed Position" value above. |
