Latest revision as of 04:30, 21 November 2011

v12-20111120

The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.
This is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".

The XYZ to FRB calculation now properly handles the linear units when converting.
The XYZ to FRB calculation now uses the default configuration to preset the FRB row options.

@@ Line 29: / Line 29: @@
 </table>
-===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation  ===
+===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation Linear Units Issue  ===
+[[image:xyz_tool_bar.jpg|500px]]
 <table cellpadding=10>
 <tr valign=top>
 <td width=400>
-* The XYZ to FRB calculation now always sets the linear units to the proper value.<br><br>
+* The XYZ to FRB calculation now properly handles the linear units when converting.<br><br>
-* The XYZ to FRB calculation now always uses the default setup to preset the FRB options.<br><br>
+* The XYZ to FRB calculation now uses the default configuration to preset the FRB row options.<br><br>
 </td>