Difference between revisions of "CNC Bender v12-20120924"
From ATTWiki
| (2 intermediate revisions by one user not shown) | |||
| Line 21: | Line 21: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | This version solved an early mandrel extraction logic problem where the mandrel will extract for a split second, then stop extracting. This is an issue on newer versions of CNC Processor that are much faster than older versions. The quickness of the loop causes the process to believe that the mandrel needs to stop retracting.<br><br> | + | This version solved an early mandrel extraction logic problem where the mandrel will extract for a split second, then stop extracting. This is an issue on newer versions of CNC Processor that are much faster than older versions. The quickness of the loop causes the process to believe that the mandrel needs to stop retracting before it has returned completely.<br><br> |
| − | CNC Processor no longer checks to see if the mandrel forward output is active before it starts the extraction. The retract output will be energized in every case during an early mandrel extraction.<br><br> | + | CNC Processor no longer checks to see if the mandrel forward output is active before it starts the extraction. The retract output will be energized in every case during an early mandrel extraction when the bend arm is in the early mandrel extraction zone.<br><br> |
| − | + | ||
| − | + | ||
</td> | </td> | ||
| Line 32: | Line 30: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Latest revision as of 19:39, 24 September 2012
v12-20120919
|
|
REPAIR: Fixed Early Mandrel Extraction Logic
|
This version solved an early mandrel extraction logic problem where the mandrel will extract for a split second, then stop extracting. This is an issue on newer versions of CNC Processor that are much faster than older versions. The quickness of the loop causes the process to believe that the mandrel needs to stop retracting before it has returned completely. CNC Processor no longer checks to see if the mandrel forward output is active before it starts the extraction. The retract output will be energized in every case during an early mandrel extraction when the bend arm is in the early mandrel extraction zone. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
