Difference between revisions of "CNC Bender v12.1.2"

From ATTWiki
Jump to: navigation, search
(Created page with "<table> <tr> <td width=400> ===v12.1.2 - August 30, 2013=== *Back to CNC Bender Software Updates *See [http://advancedtubular.com/customers/cncbender CNC Bender Customer S...")
 
(→‎New Behavoir)
 
(12 intermediate revisions by one user not shown)
Line 17: Line 17:
  
  
−
==[[image:Check.jpg|25px]] ENHANCED: Motion Recover Logic ==
+
==[[image:Check.jpg|25px]] ENHANCED: Motion Recovery Logic ==
−
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start it back up and finish the motion.<br><br>
+
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.<br>
  
−
Now the motion-recovery logic is adjusted so that motion-recovery is no longer attempted to recover motion in these circumstances:
+
===Old Behavoir===
 +
CNC Bender attempts motion-recovery in every mode - even MANUAL mode.
  
−
* The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
+
===New Behavoir===
−
* The bender has encountered a FAULT condition.
+
CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:
−
* The bender has encountered a command that is timed out.
+
−
* The E-Stop is pressed.
+
  
 +
* When the operator presses any HALT button.
 +
* The bender operation mode is in MANUAL or is entering MANUAL mode.
 +
* The bender has encountered a FAULT condition and motion is stopped.
 +
* The bender has encountered a command that is timed out and motion is stopped.
 +
* The E-Stop is pressed and released, and motion is restarted.  (This is the same as previous versions.)
 +
 +
<br><br>
  
 
==Other Pages==
 
==Other Pages==

Latest revision as of 19:57, 30 August 2013

v12.1.2 - August 30, 2013

Cncv12procontrol withteachmode.jpg



Check.jpg ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.

Old Behavoir

CNC Bender attempts motion-recovery in every mode - even MANUAL mode.

New Behavoir

CNC Bender no longer attempts to recover motion from a pause state (CYCLE HOLD is activated) in these circumstances:

  • When the operator presses any HALT button.
  • The bender operation mode is in MANUAL or is entering MANUAL mode.
  • The bender has encountered a FAULT condition and motion is stopped.
  • The bender has encountered a command that is timed out and motion is stopped.
  • The E-Stop is pressed and released, and motion is restarted. (This is the same as previous versions.)



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v12.1.2&oldid=22912"