Difference between revisions of "CNC Bender v14.8"
From ATTWiki
(→25px ENHANCED: TEST BEND PD+) |
(→25px ENHANCED: TEST BEND Pressure Die Motion) |
||
| (2 intermediate revisions by one user not shown) | |||
| Line 21: | Line 21: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | If an extra clamp is present, then it will now always open | + | If an extra clamp is present, then it will now always open BEFORE the Pressure Die Returns with a TIMER setting.<br><br> |
</tr> | </tr> | ||
</table> | </table> | ||
| − | + | <br> | |
| − | + | ||
| − | + | ||
==[[image:Check.jpg|25px]] ENHANCED: TEST BEND Pressure Die Motion == | ==[[image:Check.jpg|25px]] ENHANCED: TEST BEND Pressure Die Motion == | ||
| Line 39: | Line 37: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | + | <br> | |
| − | + | ||
| − | + | ||
==Other Pages== | ==Other Pages== | ||
Latest revision as of 02:12, 12 August 2015
v14.8 - August 11, 2014
|
|
ENHANCED: Now Extra Clamp Opens BEFORE Pressure Die Return with TIMER
|
If an extra clamp is present, then it will now always open BEFORE the Pressure Die Returns with a TIMER setting. |
ENHANCED: TEST BEND Pressure Die Motion
|
The Pressure Die open and close in the TEST BEND page can now be used even no matter where the CLAMP die is. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
