Difference between revisions of "Safe Mode Cycle Hold"
(→About the Mode) |
|||
| (39 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | [[image:cncbender_logo.jpg|400px]] | |
| + | ==About the Mode== | ||
| − | + | When operators step on the safety mat, or software puts the bender into a [[Zero Energy State]] mode. In this state, all motion axes are '''completely disabled''', and energy to all axes is blocked or stopped. | |
| + | We strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it. | ||
| − | + | <br><br> | |
| − | + | <table cellpadding="35"> | |
| + | <tr> | ||
| + | <td>[[image:warning.jpg|100px]]</td> | ||
| + | <td width=300 bgcolor="#f0f0f0"> | ||
| + | <font size=6> | ||
| + | [[image:Gear_warning.jpg]] <b>SAFETY NOTE</b><br><br> | ||
| + | </font> | ||
| + | <font size=3> | ||
| + | The only way to activate Safe Mode Cycle Hold is to either step on the safety mat or walk into the safety scanner region.<br> | ||
| + | |||
| + | <br>If you decide to work on a machine with the pump motor on, then at least step on the safety mat which disables all axes and blocks all hydraulic fluid from flowing to the hydraulic valves.<br><br> | ||
| + | |||
| + | The only device that can move in this mode is the chuck grippers/jaws. | ||
| + | </font> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ==Other Pages== | ||
| + | *Read about the [[Zero Energy State]] on our CNC Benders | ||
| + | *Read about [[Safe Mode Motion Auto Recovery]] | ||
Latest revision as of 21:19, 26 September 2009
About the Mode
When operators step on the safety mat, or software puts the bender into a Zero Energy State mode. In this state, all motion axes are completely disabled, and energy to all axes is blocked or stopped.
We strongly recommend that you require this feature for any CNC bender that you consider purchasing. Benders with this feature are much safer than benders without it.
 |
The only device that can move in this mode is the chuck grippers/jaws. |
Other Pages
- Read about the Zero Energy State on our CNC Benders
- Read about Safe Mode Motion Auto Recovery
