Difference between revisions of "CNC Bender v12-20111120"
From ATTWiki
| Line 20: | Line 20: | ||
* The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br> | * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br> | ||
* Now this is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp". | * Now this is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp". | ||
| + | </td> | ||
| + | |||
| + | <td width=300> | ||
| + | </td> | ||
| + | |||
| + | |||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation === | ||
| + | |||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=400> | ||
| + | * The XYZ to FRB calculation now always sets the linear units to the proper value.<br><br> | ||
| + | * The XYZ to FRB calculation now always uses the default setup to preset the FRB options.<br><br> | ||
</td> | </td> | ||
Revision as of 04:27, 21 November 2011
v12-20111120
|
|
CHANGE - Extra Horizontal Clamp Close
|
FIX - XYZ to FRB Calculation
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
