Revision as of 04:28, 21 November 2011

v12-20111120

The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.
This is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".

The XYZ to FRB calculation now always sets the linear units to the proper value.
The XYZ to FRB calculation now always uses the default setup to preset the FRB options.

@@ Line 19: / Line 19: @@
 <td width=400>
 * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br><br>
-* Now this is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".<br><br>
+* This is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".<br><br>
 </td>