Difference between revisions of "VTube-LASER v1.75"
From ATTWiki
| Line 20: | Line 20: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | The Split Bend logic | + | The Split Bend logic is completely rewritten and is more accurate and robust than the original logic. |
| + | <br><br> | ||
| + | New Split Bend plane object shows the plane were the split is being performed. (See the orange planes in the image on the right.) | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| Line 27: | Line 29: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
===[[image:Check.jpg|25px]] ENHANCED: Scanner Setup Saved with Project File=== | ===[[image:Check.jpg|25px]] ENHANCED: Scanner Setup Saved with Project File=== | ||
Revision as of 20:54, 27 January 2012
|
Revision 1.75Back to VTube-LASER |
|
Contents |
ENHANCED: Split Bend Logic and Display
|
The Split Bend logic is completely rewritten and is more accurate and robust than the original logic.
|
|
ENHANCED: Scanner Setup Saved with Project File
|
This version addresses issues with the new Scanner Setup in v1.74. |
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
ENHANCED: End Scan Qualification Logic
|
The end scan qualification logic was improved to work more often.
The end scans can now be inside the cylinder scans.
|
Other Changes
Other Pages
- Back to VTube-LASER
