Difference between revisions of "VTube-LASER v1.75"
| Line 80: | Line 80: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | + | A new tolerance is added for surface point diameter check. | |
| − | < | + | </td> |
| − | + | <td width=300> | |
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | <table cellpadding=10> | ||
| + | |||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes. | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 21:14, 27 January 2012
|
Revision 1.75Back to VTube-LASER |
|
Contents |
CRITICAL ENHANCEMENT: Split Bend Logic and Display
|
After extensive Gage R&R tests, the Split Bend logic is completely rewritten and is more accurate and robust than the original logic.
|
|
ENHANCED: Scanner Setup Enhancements
|
|
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
|
NEW: Cylinder Fit Radius Deviation Check
|
VTube now checks to be sure that all point clouds used in the diameter calculation all fall within a reasonable tolerance for distance from the calculated centerline.
|
|
Other Changes
|
A new tolerance is added for surface point diameter check. |
|
The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes. |
|
Other Pages
- Back to VTube-LASER
