Difference between revisions of "VTube-LASER v1.75"
| Line 52: | Line 52: | ||
<td width=300> | <td width=300> | ||
If the arm uses firmware version 702 or less, then it will display special messages when it is about to update the Scanner Control. | If the arm uses firmware version 702 or less, then it will display special messages when it is about to update the Scanner Control. | ||
| + | |||
| + | Follow these instructions if you change the Scanner Control setup from project to project. | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 21:18, 27 January 2012
|
Revision 1.75Back to VTube-LASER |
|
Contents |
CRITICAL ENHANCEMENT: Split Bend Logic and Display
|
After extensive Gage R&R tests, the Split Bend logic is completely rewritten and is more accurate and robust than the original logic.
|
|
ENHANCED: Scanner Setup Enhancements
|
|
NEW: Pull Arm From Cradle Message
|
If the arm uses firmware version 702 or less, then it will display special messages when it is about to update the Scanner Control. Follow these instructions if you change the Scanner Control setup from project to project. |
|
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
|
NEW: Cylinder Fit Radius Deviation Check
|
VTube now checks to be sure that all point clouds used in the diameter calculation all fall within a reasonable tolerance for distance from the calculated centerline.
|
|
Other Changes
|
A new tolerance is added for surface point diameter check. |
|
The current arm firmware is now read and used by VTube to determine how to handle the arm during Scanner Control changes. |
|
Other Pages
- Back to VTube-LASER
