Difference between revisions of "CNC Bender v12.1.2"
From ATTWiki
(Created page with "<table> <tr> <td width=400> ===v12.1.2 - August 30, 2013=== *Back to CNC Bender Software Updates *See [http://advancedtubular.com/customers/cncbender CNC Bender Customer S...") |
(→25px ENHANCED: Motion Recover Logic) |
||
| Line 17: | Line 17: | ||
| − | ==[[image:Check.jpg|25px]] ENHANCED: Motion | + | ==[[image:Check.jpg|25px]] ENHANCED: Motion Recovery Logic == |
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start it back up and finish the motion.<br><br> | Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start it back up and finish the motion.<br><br> | ||
| Line 26: | Line 26: | ||
* The bender has encountered a command that is timed out. | * The bender has encountered a command that is timed out. | ||
* The E-Stop is pressed. | * The E-Stop is pressed. | ||
| − | |||
==Other Pages== | ==Other Pages== | ||
Revision as of 19:28, 30 August 2013
v12.1.2 - August 30, 2013
|
|
ENHANCED: Motion Recovery Logic
Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start it back up and finish the motion.
Now the motion-recovery logic is adjusted so that motion-recovery is no longer attempted to recover motion in these circumstances:
- The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
- The bender has encountered a FAULT condition.
- The bender has encountered a command that is timed out.
- The E-Stop is pressed.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender Customer Service Page for an update.
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
