Difference between revisions of "VTube-LASER v1.99"
From ATTWiki
(→25px NEW: CSM M4 and Alpine M4 Bender Correction) |
(→25px NEW: CSM M4 and Alpine M4 Bender Correction) |
||
| Line 43: | Line 43: | ||
The two bender formats - Alpine and CSM M4, were added to VTube-LASER.<br><br> | The two bender formats - Alpine and CSM M4, were added to VTube-LASER.<br><br> | ||
This allows VTube-LASER to correct either control in a full bi-directional corrections loop.<br><br> | This allows VTube-LASER to correct either control in a full bi-directional corrections loop.<br><br> | ||
| − | This new feature also stores all the YBC data in the M4 format - which | + | This new feature also stores all the YBC data in the M4 format '''inside the VTube project files''' - which means the bender setup is stored along with the project and recalled when the project is loaded back into VTube. |
</td> | </td> | ||
<td width=500> | <td width=500> | ||
Revision as of 01:18, 26 November 2014
|
Revision 1.99
|
|
ENHANCEMENT: "Pull Arm from Cradle" Message Removed for Automatic Scan Modes
|
The message is of no value when the arm is running in automatic scan mode. It should only display when the scan algorithm is set to FIXED. This saves confusion for arm users that always use AUTOMATIC modes. So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. |
NEW: CSM M4 and Alpine M4 Bender Correction
|
The two bender formats - Alpine and CSM M4, were added to VTube-LASER. |
|
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor
