Difference between revisions of "VTube-LASER v1.99"
(→25px NEW: CSM M4 and Alpine M4 Bender Correction) |
(→25px ENHANCEMENT: "Pull Arm from Cradle" Message REMOVED for Automatic Scan Modes) |
||
| Line 31: | Line 31: | ||
<td width=500> | <td width=500> | ||
[[image:vtube-laser-1.99_armcradle_message.png|400px]] | [[image:vtube-laser-1.99_armcradle_message.png|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCEMENT: Additional Setup Button Added for Winton WMC in Bender Setup=== | ||
| + | |||
| + | <table cellpadding=10 width=800> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | This new button allows users to modify the bender setup file before sending data to the bender.<br><br> | ||
| + | |||
| + | </td> | ||
| + | <td width=500> | ||
| + | [[image:VTube--LASER-1.99_WMC_BenderSetup_AdditionalSetupButton.png|400px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 01:33, 26 November 2014
|
Revision 1.99
|
|
ENHANCEMENT: "Pull Arm from Cradle" Message REMOVED for Automatic Scan Modes
|
The message is of no value when the arm is running in automatic scan mode. It should only display when the scan algorithm is set to FIXED. This saves confusion for arm users that always use AUTOMATIC modes. So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. |
|
ENHANCEMENT: Additional Setup Button Added for Winton WMC in Bender Setup
|
This new button allows users to modify the bender setup file before sending data to the bender. |
|
ENHANCEMENT: Arm Connected LED Lamp Added to Arm Utilties
|
This new LED indicates that the arm is connected to the Arm Utilities menu. |
|
NEW: Alpine M4 Bender Correction
|
The Alpine M4 bender format was added to VTube-LASER. |
|
NEW: CSM M4 Bender Correction
|
The CSM M4 format was added to VTube-LASER. |
|
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor
