Difference between revisions of "Recommended VTube-LASER Laser Scanner Settings"

• Back to VTube-LASER

The FARO ScanArm HD blue laser scanner has significantly increased capabilities compared to earlier FARO scanners.

Because of that, it requires different setup recommendations for the FARO Laser Line Probe Control window. These settings work very well in VTube-LASER specifically with the HD scanner.

VTube-LASER be connected to a FARO arm to perform these steps.

STEP 1

In VTube-LASER window click on Scanner Algorithm label above the viewport window.

This loads the FARO Laser Line Probe Control window.

STEP 2

Set the Scan Rate to 1/1.

• This value will allow the laser stripes to come into VTube-LASER as quickly as the FARO driver can send them.
  
  

Set the Scan Density to 1/16

• This value will reduce density of the points in the laser line returned to VTube-LASER.
  
  
• Since VTube-LASER removes some of points with a Maximum Number of Points Allowed in Cylinder Laser Stripe filter, it works faster if the FARO driver removes some of those points in advance. Both scanning and calculation can be many times faster when the Scan Density is reduced to anything less than 1/1.

STEP 3

For most materials set the Algorithm to Automatic - Normal.

STEP 4

Uncheck the Reflection Filter option.

• The FARO reflection filter makes FARO stop returning points when the scanner is moving, so scanning seems to stop and start even with the green button pressed.
  
  
• There doesn't seem to be significant benefit for tube scanning with this filter on - and VTube will remove spiked outliers automatically with the spike filter - so this filter is redundant.

STEP 5

Click on the OK button to exit the FARO Laser Line Probe window.

This completes the setup.