Difference between revisions of "Revision: Benderlink for BLM 3.2"
| Line 26: | Line 26: | ||
<br><br> | <br><br> | ||
| − | ===[[image:Check.jpg|25px]] | + | ===[[image:Check.jpg|25px]] Set the Linear Units for Conversion=== |
<table cellpadding="15" width = 650> | <table cellpadding="15" width = 650> | ||
<tr valign="top"> | <tr valign="top"> | ||
<td width = 200> | <td width = 200> | ||
| − | Benderlink now | + | Benderlink now shows two radio-buttons in the Measuring Center section that allow the operator to send the data to the measuring center in a consistent unit value. |
</td> | </td> | ||
<td bgcolor="#e3e4f5"> | <td bgcolor="#e3e4f5"> | ||
| − | [[image: | + | [[image:Benderlink_blm_unitsend.jpg]] |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 40: | Line 40: | ||
<br><br> | <br><br> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] New Convert SV Part Number to UPPER Case === | ===[[image:Check.jpg|25px]] New Convert SV Part Number to UPPER Case === | ||
Revision as of 20:49, 7 December 2007
New Recognition of Variable Radius Bending
|
BLM benders can bend using draw bending or push-bending. BLM refers to push-bending as "variable radius bending." This version of Benderlink can recognize large radius push-bends and skip corrections to straights before and after push-bends. Also the bend angle of each push-bend is left untouched. |
|
Benderlink indicates which values are not corrected by showing a bold red value on the screen. The BLUE radius values indicates the Benderlink knows that this is a variable radius bend. |
|
Set the Linear Units for Conversion
|
Benderlink now shows two radio-buttons in the Measuring Center section that allow the operator to send the data to the measuring center in a consistent unit value. |
|
New Convert SV Part Number to UPPER Case
|
Benderlink now automatically converts all SV part numbers to upper case when converting from BLM data. |
|
Other Pages
Main Benderlink Wiki page
Main Benderlink for BLM Wiki page
