Revision as of 22:18, 4 November 2009

The final bend arm return motion now allows logic to continue even if it is still moving back.
The Bend Return Step Point value in the last row controls when the final bend arm return will release the processlist to move back to the beginning of the program.

A new [BEGIN RUN AGAIN] label is used to trim off processing time by bypassing commands that only need to be run once at the top of each process list. (bend program)
The result is to potentially trim seconds of each cycle.

USe the new high-speed constant run list for processes that should run all the time and get high attention.
Control the interval of how often the list runs in the Processor tab in the Low Level menu.

@@ Line 44: / Line 44: @@
 <br><br>
-===[[image:Check.jpg|25px]] NEW - FRB  EVEN or ODD Row COPY ===
+===[[image:Check.jpg|25px]] NEW - HIGH SPEED Constant Run List ===
 <table cellpadding=5>
 <tr>
 <td width=300>
-* Now there are EVEN and ODD Rows buttons that replace the UP ONE or DOWN ONE buttons.
+* USe the new high-speed constant run list for processes that should run all the time and get high attention.<br><br>
-<br><br>
+* Control the interval of how often the list runs in the Processor tab in the Low Level menu.
-* These buttons can copy the current value to all EVEN or ODD rows for setup patterns that repeat in the FRB rows.
 </td>
 <td width=350>
-[[image:FRBoption_copy_oddeven.jpg|500px]]
+[[image:HighSpeedConstantRun.jpg|500px]]
 </td>
 </tr>
 </table>
 ===[[image:Check.jpg|25px]] FIX - KEYBOARD Repairs===

Difference between revisions of "CNC Bender v11-20091104"