|
|
| Line 27: |
Line 27: |
| | | | |
| | | | |
| − | ===[[image:Check.jpg|25px]] NEW - TEACH MODE and CUSTOM COMMANDS=== | + | ===[[image:Check.jpg|25px]] NEW - TEACH MODE=== |
| | <table> | | <table> |
| | <tr valign=middle> | | <tr valign=middle> |
- CNC Bender can now learn from you during setup. Teach the bender any motion for difficult transitions between bends
- The learned moves are held in objects called Custom Commands.
- PreBend allows for 10 Custom Commands. They run immediately after you press the run buttons.
- Each BEND can be followed by up to 10 Custom Commands.
- Control extra moves in PostBend using the final bend's Custom Commands.
- Each Custom Command can contain any number of simultaneous Jog Motions. In a SINGLE Custom Command, you could teach the bender how to move the...
- FEED (carriage)
- while ROTATING
- while shifting the VERTICAL RADIUS
- while shifting the HORIZONTAL RADIUS
- while returning the BEND ARM
- while pulling the MANDREL
- while activating the KICKER
- while doing anything else you can make move on the bender
- So Custom Commands can control all axes and actuators around the bender including directional valves - clamp, pressure die, kickers, grippers, mandrel, mist, machine lube - ANY ACTUATOR.
- Custom Commands can be MANUALLY entered and edited. You can enter Custom Commands without Teach Mode.
- Custom Commands can be edited even after they were learned during Teach Mode.
|
 New TEACH speed button in the Control Mode bar  Teach Mode activates after a Teach Mode Section was encountered during bending
 Custom Command Editor during Teach Mode
|
|
|
 FRB menu with Edit Custom buttons after each bend |
- CNC Bender can now learn from you during setup. Teach the bender any motion for difficult transitions between bends
- The learned moves are held in objects called Custom Commands.
- PreBend allows for 10 Custom Commands. They run immediately after you press the run buttons.
- Each BEND can be followed by up to 10 Custom Commands.
- Control extra moves in PostBend using the final bend's Custom Commands.
- Each Custom Command can contain any number of simultaneous Jog Motions. In a SINGLE Custom Command, you could teach the bender how to move the...
- FEED (carriage)
- while ROTATING
- while shifting the VERTICAL RADIUS
- while shifting the HORIZONTAL RADIUS
- while returning the BEND ARM
- while pulling the MANDREL
- while activating the KICKER
- while doing anything else you can make move on the bender
- So Custom Commands can control all axes and actuators around the bender including directional valves - clamp, pressure die, kickers, grippers, mandrel, mist, machine lube - ANY ACTUATOR.
- Custom Commands can be MANUALLY entered and edited. You can enter Custom Commands without Teach Mode.
- Custom Commands can be edited even after they were learned during Teach Mode.
|
New TEACH speed button in the Control Mode bar Teach Mode activates after a Teach Mode Section was encountered during bending
Custom Command Editor during Teach Mode
|
|
|
FRB menu with Edit Custom buttons after each bend |
NEW - TEACH MODE
