Difference between revisions of "VTube-LASER v1.57"
| Line 46: | Line 46: | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| − | [[image:vtube- | + | [[image:vtube-laser_1_57_bendersetup_toolbar.jpg|300px]]. |
</td> | </td> | ||
</tr> | </tr> | ||
| Line 52: | Line 52: | ||
<br><br> | <br><br> | ||
| − | |||
===[[image:Check.jpg|25px]] ENHANCED: Springback Compensation for Correction Adjustments === | ===[[image:Check.jpg|25px]] ENHANCED: Springback Compensation for Correction Adjustments === | ||
Revision as of 14:09, 12 January 2011
|
Revision 1.57Back to VTube-LASER |
|
NEW: Recall the BENDER MASTER XYZ to Establish the VTube Master
|
You can now ask the bender to give you the MASTER XYZ data if that data exists on the bender.
|
|
ENHANCED: Bender Setup Menu Redesigned
|
The Bender Setup user interface menu was redesigned.
|
ENHANCED: Springback Compensation for Correction Adjustments
|
The realtime springback compensation values in the Bender Setup menu are now calculated based on the adjustment value alone. So - if the adjustment value for a 90 degree bend is found to be +3 degrees, then the springback compensation added to the bend is calculated based on 3 degrees, not 93 degrees. |
|
NEW: Transfer Master LRA to Setup LRA Springback Compensation
| When transferring data from the MASTER LRA to the BENDER SETUP LRA, automatic springback compensation is automatically applied if the springback values are non-zero. |
|
NEW: Part Name in Toolbar
|
The current part name is now displayed in the toolbar below the VTube-LASER logo. |
|
NEW- Springback Values Transfer from Overbend
|
VTube-LASER can now receive springback data from Overbend with the press of a single button in the Overbend Calculator. |
|
NEW: Transfer New Values in Supravision Protocol
|
New values are included in Supravision file transfers (imports/exports/bender corrections):
|
|
ENHANCED - Other Changes
Other Pages
- Back to VTube-LASER
