Difference between revisions of "VTube-LASER v1.62"
From ATTWiki
| Line 36: | Line 36: | ||
<td width=200> | <td width=200> | ||
VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.<br><br> | VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points.<br><br> | ||
| − | + | A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim. | |
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 05:08, 12 March 2011
|
Revision 1.62Back to VTube-LASER |
|
ENHANCED: End Scans Faster
|
Analysis of end scans is now much faster.
|
|
NEW: Multiple Point Qualification End Scan
|
VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. |
|
REPAIR: Diameter and Wall Detection for STEP Mode
| See VTube-STEP v1.62 for details. |
|
Other Changes
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
