Difference between revisions of "CNC Bender v12-20111120"
From ATTWiki
| Line 18: | Line 18: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br> | + | * The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE.<br><br> |
| − | * Now this is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp". | + | * Now this is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".<br><br> |
</td> | </td> | ||
| Line 28: | Line 28: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation === | ===[[image:Check.jpg|25px]] FIX - XYZ to FRB Calculation === | ||
Revision as of 04:27, 21 November 2011
v12-20111120
|
|
CHANGE - Extra Horizontal Clamp Close
|
FIX - XYZ to FRB Calculation
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
