Difference between revisions of "VTube-LASER v1.75"
From ATTWiki
| Line 30: | Line 30: | ||
</table> | </table> | ||
| − | ===[[image:Check.jpg|25px]] ENHANCED: Scanner Setup | + | ===[[image:Check.jpg|25px]] ENHANCED: Scanner Setup Enhancements=== |
<table cellpadding=10> | <table cellpadding=10> | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | This version addresses issues with the new Scanner Setup in v1.74. | + | * This version addresses issues with the new Scanner Setup in v1.74. |
| + | * The current scanner setup is now displayed below the DRO. | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 21:09, 27 January 2012
|
Revision 1.75Back to VTube-LASER |
|
Contents |
CRITICAL ENHANCEMENT: Split Bend Logic and Display
|
After extensive Gage R&R tests, the Split Bend logic is completely rewritten and is more accurate and robust than the original logic.
|
|
ENHANCED: Scanner Setup Enhancements
|
|
NEW: Separate Cylinder Fit Tolerances for LONG and SHORT Cylinders
|
VTube now has a second set of tolerances for shorter straights. This allows for looser tolerances on shorter straights without producing an error message.
|
|
NEW: Cylinder Fit Radius Deviation Check
|
VTube now checks to be sure that all point clouds used in the diameter calculation all fall within a reasonable tolerance for distance from the calculated centerline.
|
|
Other Changes
|
Other Pages
- Back to VTube-LASER
