Difference between revisions of "VTube-STEP v1.77"
| Line 56: | Line 56: | ||
Linear units are now always properly imported into VTube from TubeCalc files.<br><br> | Linear units are now always properly imported into VTube from TubeCalc files.<br><br> | ||
Previous versions would sometimes improperly interpret the Inch or Millimeter setting in the TubeCalc file. | Previous versions would sometimes improperly interpret the Inch or Millimeter setting in the TubeCalc file. | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] ENHANCED: The Linear Units Switches to the Import File Units=== | ||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | VTube now always switches to the linear units used in the imported TubeCalc, Solid Edge, or Supravision file<br><br> | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
Revision as of 02:25, 11 July 2012
|
Revision 1.77
|
|
NEW: Adjustable Import/Export Interface with New Choices
|
The Import/Export interface is now expandable/compressible.
(Note about the XpresRoute import: This file format uses bender LRA data to define the tube shape, therefore the original orientation of the part is lost during export from Solid Edge. Also this file does not contain the tube diameter. However, it does bring in the part name, the linear display unit, the cut length, and the LRA bender data.)
|
|
NEW: Reset Origin to Zero in XYZ Data
|
Now you can reset the origin in the XYZ data to ZERO in VTube-STEP. |
|
REPAIR: The TubeCalc Project File Linear Units Import
|
Linear units are now always properly imported into VTube from TubeCalc files. |
ENHANCED: The Linear Units Switches to the Import File Units
|
VTube now always switches to the linear units used in the imported TubeCalc, Solid Edge, or Supravision file |
Other Pages
- Back to the VTube page
