Difference between revisions of "VTube Rectangular Tubes"
From ATTWiki
(→VTube Rectangular Tubes) |
|||
| Line 21: | Line 21: | ||
<tr> | <tr> | ||
<td width=600> | <td width=600> | ||
| − | VTube-STEP and VTube-LASER can draw, calculate, and measure rectangular tube shapes.</td> | + | As of version 1.82, VTube-STEP and VTube-LASER can draw, calculate, and measure rectangular tube shapes.</td> |
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
<table width=700> | <table width=700> | ||
Revision as of 22:17, 24 June 2013
|
|
| As of version 1.82, VTube-STEP and VTube-LASER can draw, calculate, and measure rectangular tube shapes. |
|
VTube can draw rectangular or square tubing. The dimensional controls are in the Part Setup menu of both STEP and LASER modes: |
|
Contents |
VTube - Profile Shapes
Square TubeSet Width1 and Width2 to the same values to draw square tube. |
|
Rectangular - Bending "Easy Way"This profile orientation is referred to as the "easy way" bending in the tubing industry. The reason is because this orientation is easier to bend than a profile rotated 90 degrees to this. |
|
Rectangular - Bending "Hard Way"You can switch the values in the Width1 and Width2 to rotate the tube shape into the "hard way" bending method. |
|
VTube - Profile Rotations
Square TubeSet the Rectangular Angle to rotate the profile of a square tube relative to the plane of the first bend. |
|
Rectangular TubeThe same rotation feature works for rectangular tubing. |
|
Other Pages
- Back to VTube-STEP
- Back to VTube-LASER
