Difference between revisions of "Revision: Benderlink for Chiyoda/Keins 6.8"

Revision 6.8

Back to Benderlink for Chiyoda
Back to Benderlink for KEINS

This Benderlink allows every bender to have a unique storage path on the drive or network. This gives the huge benefit of keeping the files for each bender separate.

Benderlink can now stop the process and ask for input if a zero diameter is encountered.

If this feature is deactivated, then Benderlink will ignore zero value radii values. In this case, Benderlink will automatically change a zero value diameter to non-zero using this formula:

(Rad Level 1) / 1.5

If the Rad Level 1 value is zero, then Benderlink will use this formula:

(Rad Level 2) / 1.5

• If both radius level values are zero, then Benderlink will set the diameter to 1 unit.
  
  A non-zero diameter is important for communicating with ROMER DOCS software because DOCS will report a corrupted file if it senses a zero diameter. (Some measuring center software packages, like VTube-LASER will continue with a zero diameter.)
  
  
• If the radius stop is enabled, and Benderlink stops for input while the measuring center is performing a recall, then the recall process will time out if the new diameter is not entered within the time out period.