Difference between revisions of "VTube-LASER v1.99"
From ATTWiki
(→25px NEW: CSM M4 and Alpine M4 Bender Correction) |
(→25px ENHANCEMENT: "Pull Arm from Cradle" Message Removed for Automatic Scan Modes) |
||
| Line 20: | Line 20: | ||
| − | ===[[image:Check.jpg|25px]] ENHANCEMENT: "Pull Arm from Cradle" Message | + | ===[[image:Check.jpg|25px]] ENHANCEMENT: "Pull Arm from Cradle" Message REMOVED for Automatic Scan Modes=== |
<table cellpadding=10 width=800> | <table cellpadding=10 width=800> | ||
| Line 33: | Line 33: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] NEW: CSM M4 and Alpine M4 Bender Correction=== | ===[[image:Check.jpg|25px]] NEW: CSM M4 and Alpine M4 Bender Correction=== | ||
Revision as of 01:19, 26 November 2014
|
Revision 1.99
|
|
ENHANCEMENT: "Pull Arm from Cradle" Message REMOVED for Automatic Scan Modes
|
The message is of no value when the arm is running in automatic scan mode. It should only display when the scan algorithm is set to FIXED. This saves confusion for arm users that always use AUTOMATIC modes. So now VTube only displays the message if the scanner is setup in the VTube Project file for FIXED mode. |
NEW: CSM M4 and Alpine M4 Bender Correction
|
The two bender formats - Alpine and CSM M4, were added to VTube-LASER. |
|
Other
- Back to VTube-STEP
- Back to VTube Software Updates (for LASER Mode)
- Back to VTube-LASER
- See VTube Language Editor
