Difference between revisions of "Revision: Benderlink for BLM 5.3"
(→25px NEW - Switch for Do Not Allow Measuring Center to Change End Lengths) |
(→25px NEW - Switch for "Do Not Allow Measuring Center to Change End Lengths") |
||
| Line 58: | Line 58: | ||
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
| − | During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position.<br><br> | + | During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position even after corrections are applied.<br><br> |
This version of Benderlink now includes this checkbox switch to turn this feature on or off. | This version of Benderlink now includes this checkbox switch to turn this feature on or off. | ||
</td> | </td> | ||
Revision as of 22:01, 14 October 2015
|
Revision 5.3
|
|
- See Benderlink for BLM Customer Support Page to download the latest version.
NEW - Large Green LED to Show Measuring Center Monitoring
|
A new larger green LED port indicator to show that Benderlink is monitoring for measuring center communications is added to the interface. |
|
NEW - Communications Transfers No Longer Change the BLM Radius Levels
|
Setting or changing BLM radius levels could easily cause radius level mix ups during corrections loops. The radius levels are no longer touched or changed during transfer. |
|
NEW - Switch for "Do Not Allow Measuring Center to Change End Lengths"
|
During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position even after corrections are applied. |
|
ENHANCED - The Communications Protocol is Enhanced for LASERVISION Windows Version
|
The internal communications logic was enhanced to work properly with Windows versions of LASERVISION. (It already worked with DOS versions of LASERVISION.) |
|
NEW - Click on LEDs to Toggle to Measuring Center Monitoring
|
You can now click on either LED indicator to toggle monitoring for the measuring center commmands. |
|
FIXED - Ping Port Confirmation Works in Newer Windows
|
This feature allows Benderlink to ping for a serial device server before opening a virtual port. |
|
NEW - Message Warning for Ports That Cannot Open
|
When a port to the measuring center cannot open, Benderlink now displays a message that a problem occurred. |
|
Other Pages
- Back to Benderlink for BLM Revisions
- Back to Benderlink for BLM
- Back to Benderlink
- Go to the main website Benderlink for BLM page
- About BLM Group USA
