Difference between revisions of "Using a Datum to Get Print Dimensions"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 300px ==How to Use Datums To Get Print Dimensions== </td> <td width=300> image:vtube-lase...") |
(→Sample Print) |
||
| Line 23: | Line 23: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | This is a sample print with the design intent of checking the width and the height. You can use the VTube-LASER DATUM feature to get to these dimensions</td> | + | This is a sample print with the design intent of checking the width and the height. You can use the VTube-LASER DATUM feature to get to these dimensions.<br><br> |
| + | The diameter of this part is 1.25 inches. You will need to find the X centerline dimension by subtracting 1.25 from 5.5. So - the X dimension should be 5.5 - 1.25 = 4.25.</td> | ||
<td> | <td> | ||
[[image:sampleprint.png|500px]] | [[image:sampleprint.png|500px]] | ||
Revision as of 15:52, 28 March 2018
|
How to Use Datums To Get Print Dimensions |
|
Sample Print
|
This is a sample print with the design intent of checking the width and the height. You can use the VTube-LASER DATUM feature to get to these dimensions. |
|
MultiScan Measurements
|
MulitScan only measures near the tangents of a straight. (The tangents are the locations on the straights where the straights and bends meet.) |
MTA Measurements
| MTA (Measured Tube Averaging), combined with UniScan measuring, is the the best type of measuring available in VTube-LASER. MTA allows you to measure multiple sides of the same tube, then average the results into a single final tube shape. |
|
Other Pages
- Back to VTube-LASER
