Difference between revisions of "Cable Spec 33"
From ATTWiki
(→CB-EL1 Board Setup For Use With Cable 33) |
(→Other Pages) |
||
| Line 17: | Line 17: | ||
The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection. Do not use v1 in this configuration.<br><br> | The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection. Do not use v1 in this configuration.<br><br> | ||
[[image:cb-el1_bendermode.jpg|800px]] | [[image:cb-el1_bendermode.jpg|800px]] | ||
| + | |||
| + | ==Breakout Tester== | ||
| + | |||
| + | Use a breakout tester for continuity checks like this: | ||
| + | <br><br> | ||
| + | [[image:cable_33_breakout_test.png|600px]] | ||
| + | |||
==Other Pages== | ==Other Pages== | ||
*[[Cable Spec]]s | *[[Cable Spec]]s | ||
Revision as of 16:28, 23 August 2022
For use inside Benderlink Ethernet Modules with current loop electronics.
Use for simulating the PREMIER (Bender) side only.
Wiring schematic:
CB-EL1 Board Setup For Use With Cable 33
In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center. You can also use this cable to replace the current loop board at a Premier bender.
The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection. Do not use v1 in this configuration.
Breakout Tester
Use a breakout tester for continuity checks like this:
