Difference between revisions of "CNCProcessor.cfg"
From ATTWiki
(→Properties for Older Versions of CNC Bender) |
|||
| Line 11: | Line 11: | ||
<pre>[Machine Lube]</pre> | <pre>[Machine Lube]</pre> | ||
| − | === | + | ===Example Setup=== |
| − | + | ||
| − | + | ||
| + | This is an example configuration setup: | ||
<pre> | <pre> | ||
[Machine Lube] | [Machine Lube] | ||
Revision as of 20:57, 28 January 2009
What is It?
The CNCProcessor.cfg file exists in the c:\cnc\config folder. It contains setup information for the CNC Processor.
Sections
Each of the sections in the CNCProcessor.cfg is set apart with values in square brackets like this:
[Machine Lube]
Example Setup
This is an example configuration setup:
[Machine Lube] Machine Lube Duration=5000 Lube Machine At Bend Count=100 Pulse Machine Lube Pump=1 Watch For Machine Lube Complete Input=0 [CIO] CIO Name Of Input Clamp Die Close=Input_ClampIsClosed_End CIO Name Of Input Pressure Die Home=Input_PressureDieIsHome_End CIO Name Of Input Pressure Die Close=Input_PressureDieIsClosed_End CIO Name Of Input Carriage Cross Slide Advance=Input_CarriageCrossSlideIsAdvanced_End CIO Name Of Input Release Button=Input_Release_Button_End CIO Name Of Output Release Illuminate=Output_Release_Illuminate CIO Name Of Boost Bottom Advance=Output_BoostBottom_Advance CIO Name Of Boost Top Advance=Output_BoostTop_Advance CIO Name Of Bend Positive=MOVE_BEND_POS_RELATIVE CIO Name Of Output Machine Lube=Output_MachineLube_Repeat CIO Name of Input Machine Lube Complete=Input_MachineLubeComplete_End CIO Name Of Output Bend Head Down1=Output_HeadShiftDown1_Repeat CIO Name Of Output Bend Head Down2=Output_HeadShiftDown2_Repeat CIO Name Of Output Bend Head Center1=Output_HeadShiftCenter1_Repeat CIO Name Of Output Bend Head Center2=Output_HeadShiftCenter2_Repeat CIO Name Of Output Bend Head Up1=Output_HeadShiftUp1_Repeat CIO Name Of Output Bend Head Up2=Output_HeadShiftUp2_Repeat [SOUND] INIT=cncbender_initialized.wav AE=all_axes_enabled.wav AD=all_axes_disabled.wav WRE=warning_range_error_encountered.wav CH=cycle_hold.wav CS=cycle_start.wav MM=manual_mode.wav SM=step_mode.wav AM=auto_mode.wav SMMF=switch_to_manual_mode_first.wav [Loop] Power Off Manual Mode Pause=5 Power On Manual Mode Pause=5 Cycle Hold Pause=5 [Opcode] Transform 2031 Enabled=0 Transformed 2031=2023 [PRIORITY] Master Loop Priority=10000
Note that remarks may be added to the file with lines preceded by double forward slashes.
// How long does the machine loop output enable?
Properties Definition
Read about individual properties:
These two properties control the Auto Lube feature:
Machine Lube Duration
Lube Machine At Bend Count
