VTube-LASER v1.62

Revision 1.62 Back to VTube-LASER

ENHANCED: End Scans Faster

Analysis of end scans is now much faster. When end-scans are taking more time than a few seconds, a progress window will display.

NEW: Scan Rate Types: Timer or Distance

Now all scan rates are determined by either a TIMER or a DISTANCE. For end-scans, use a timer and set the timer value to 0 milliseconds. For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation.

NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Issues with this version fixed in next version

No known issues

Other Pages

• Back to VTube-LASER