CNC Bender v12.1.2

v12.1.2 - August 30, 2013 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start it back up and finish the motion.

Now the motion-recovery logic is adjusted so that motion-recovery is no longer attempted to recover motion in these circumstances:

• The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
• The bender has encountered a FAULT condition.
• The bender has encountered a command that is timed out.
• The E-Stop is pressed.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands