CNC Bender v15.9.5

From ATTWiki
Revision as of 22:50, 14 September 2017 by Mcone (Talk | contribs)

Jump to: navigation, search

v15.9.5 - September 14, 2017

Cncbender v15 logo.png


Check.jpg NEW: Added Jog Motion "End Custom Commands"

When building Custom Commands, it is helpful to be able to indicate when a Custom Command is the last one in order to save time in the run cycle.

When CNC Bender Processor encounters this command, it skips to the end of that custom command section in the process list.

Cnc v15.9.5 End Custom Commands In Editor.png

Cnc v15.9.5 End Custom Commands Skip All Below.png

Check.jpg FIXED: Window Border Feature

The Window border feature now correctly maximizes the CNC Bender window when the window border is toggled OFF.

Cnc v15.9.5 Toggle Border.png



Check.jpg FIXED: Motion PDA Crash Protection in Manual Absolute

This change is for motion-controlled PDAs.

CNC Bender no longer allows the PDA to move forward to an ABSOLUTE position when the bend arm is positioned less than 90 degrees.

Cnc v15.9.5 PDA Absolute Protect.png




Check.jpg FIXED: Galil Communications Reset Issue

CNC Bender can sometimes request a Galil motion controller communications reset on slower computers.

This has been resolved.

Galil dmc module.png




Check.jpg FIXED: Call to Windows Onscreen Keyboard Working Again

CNC Bender could not load the Windows onscreen keyboard in Windows 7 and Windows 10 in 64 bit mode.

This has been resolved.

Cnc v15.9.5 osk.png



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=CNC_Bender_v15.9.5&oldid=35368"