VTube-LASER v2.9.9

Revision 2.9.9 Release Date: June 11, 2018 Current Build: 1 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW - SCP Feature (Stripe Cut Plane) - Eliminates LASER Stripe Data That Is Too Far From the Probe

The new STRIPE CUT PLANE feature is included in the CUT PLANE CONTROL Window. It will automatically remove entire stripes that are captured too far from the stripe nearest the probe. The goal is to ensure that the scanner does not accidentally catch any object in a stripe that is far away from the first diameter relative to the probe. This is helpful for smaller parts because the scanners have an active depth range that allows them to pick up stripes that are within a 127mm (5 inch) inch range top to bottom. SCP works with the DCP feature to ensure that no stray data is used in a scan like this: - The CUT PLANE feature removes any surface data found below standard cut planes that are active. - The DCP (DIAMETER CUT PLANE) feature removes the tails of stripes. - The SCP (STRIPE CUT PLANE) feature then removes any stripe remaining that is too far from the probe.

FIX- MTA (Measured Tube Averaging)

We discovered that the MTA feature would record all the tubes and build he average in Tube Data Storage, but would not copy it into main memory. This has been fixed.

NEW - SHOW "SPLIT BENDS PRESENT" in WARNING HEADER

When Split Bends are present (180-degree bends or greater), then a new message displays in the header: "Split bends present", and turns the header yellow.

NEW - End-A and End-B OFFSET VALUES IN REPORTS

The offset values are the same as the old Supravision "tangent" end points in the Critical Reports section of the Inspection Data report. The new tokens for this data are: A-EndOffset B-EndOffset

ENHANCED - SPLIT BEND FEATURE

The Split Bend calculations in STEP mode are improved from previous versions. The Split Bends are set to ACTIVE automatically when importing Split Bends.

ENHANCED - FLOATING TOOL WINDOWS STAY ON TOP

The floating windows have some enhancements in this version that ensures that they stay on top of parent windows.

OTHER CHANGES

The part number is automatically inserted in the "Displayed in UI" box above the menus when a CAD model is imported. The internal configuration engine was updated in order to solve some minor configuration file issues.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature