CNC Bender v12-20111120

v12-20111120 Back to CNC Bender Software Updates

CHANGE - Extra Horizontal Clamp Close

The extra horizontal clamp only closed when the CLAMP die was closed separately from the PRESSURE DIE. This is changed so that it also closes in the PD/Clamp Close Method of "PD AND Clamp".

FIX - XYZ to FRB Calculation

The XYZ to FRB calculation now always sets the linear units to the proper value. The XYZ to FRB calculation now always uses the default setup to preset the FRB options.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands