CNC Bender v15.9.5

v15.9.5 - September 14, 2017 Back to CNC Bender Software Updates

BIG CHANGE: CYCLE TIME REDUCTION for CUSTOM COMMAND USERS

If you use CUSTOM COMMANDS in any of your bend programs in CNC Bender ProControl, then we strongly recommend that you upgrade your CNC Bender for this feature alone. The big change in this version is that CNC Bender allows the operator to skip unused CUSTOM COMMANDS in the process list. The end effective can be shaving several seconds off of cycle times for parts that use CUSTOM COMMANDS for avoidance moves during bending.

NEW: Added Jog Motion "End Custom Commands"

When building Custom Commands, it is helpful to be able to indicate when a Custom Command is the last one in order to save time in the run cycle. When CNC Bender Processor encounters this command, it skips to the end of that custom command section in the process list.

FIXED: Window Border Feature

The Window border feature now correctly maximizes the CNC Bender window when the window border is toggled OFF.

FIXED: Motion PDA Crash Protection in Manual Absolute

This change is for motion-controlled PDAs. CNC Bender no longer allows the PDA to move forward to an ABSOLUTE position when the bend arm is positioned less than 90 degrees.

FIXED: Galil Communications Reset Issue

CNC Bender can sometimes request a Galil motion controller communications reset on slower computers. This has been resolved.

FIXED: Call to Windows Onscreen Keyboard Working Again

CNC Bender could not load the Windows onscreen keyboard in Windows 7 and Windows 10 in 64 bit mode. This has been resolved.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands