Benderlink Ethernet Module
Put SERIAL Port Benders on a Wireless or Wired NETWORK at Extended Distances
The module connects any bender or measuring center devices through your Ethernet network to a bender that normally connects using only standard RS-232 signals. It gives your bender or measuring center access to a virtual COM port anywhere on the network in your building. Distance limitations are removed with this protocol. We have WiFi (wireless) and WIRED TCP/IP models.
Connect to EL Vector Tube Data Centers Using Current Loop Electronics
The module can even be equipped with our version of the Eaton Leonard current loop boards (our own model called the CB-EL1) to allow for 100% compatible Eaton Leonard legacy protocol through the network for connection to an EL Vector Tube Data Center
Connect ROMER to Eaton Leonard Benders Using Current Loop Electronics
|
The module, equipped with our current loop electronics, can be used to connect the ROMER measuring center to Eaton Leonard benders. See ROMER to Eaton Leonard Benders |
|
Connect AICON to Eaton Leonard Benders Using Current Loop Electronics
|
The module, equipped with our current loop electronics, can be used to connect the AICON measuring center to Eaton Leonard benders. See AICON to Eaton Leonard Benders |
|
| This is a module with cables in place. Three cables are attached to the wired version. A fourth wireless antenna cable is attached for wireless version. |
|
Examples:
| Bender | Description | |
|---|---|---|
| PINES TS-2000 | Using Benderlink for Pines - Add a module to a Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| BLM VGP | Using Benderlink for BLM - Add a module to Vector Tube Data Center to enable a network connection through a current-loop module directly into the standard Vector bender port. | |
| ROMER to Eaton Leonard Bender | Add a module to any Eaton Leonard bender and make it wireless. | |
| CHIYODA | Add this module to a Chiyoda to allow it to communicate over the network from its RS-232 port. | |
| KEINS | Add this module to a KEINS to allow it to communicate over the network from its RS-232 port. | |
| MiiC | Works with a MiiC to place it on the network (See Benderlink for MiiC) | |
PDF DataSheets
|
|
Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard
|
